I am hoping that I am simply not catching something with the PC configuration and setup.īut it also seems peculiar that there is only an "XP optimization" reference file available from Artsoft, not one for 7, even though it has been asked for a couple times right here on the Machsupport forum.Īny suggestions would be most appreciated! My computer skills are at most, basic, and questions directed to those more knowledgeable often take for granted my knowledge base. I certainly could use a better understanding of the test, to say the least. My limited understanding of the drivertest is that you want a very flat line, but no joy there for me. And both of those PCs yielded less than desirable results in actual operation on my small 3 axis router. Well I haven't connected this one to the router, but the drivertest utility results appear near identical to the first two PCs, very "spikey". This is my third attempt (mildly frustrated, to put it lightly) at a new,clean install, custom built, dedicated PC for the purpose, and still no joy. If so, anyone successful with this willing to walk me through troubleshooting erratic, inconsistent "clunks" from the step motors on my router. Does Mach3 work reliably with Windows 7 32bit and the parallel port? It seems very odd that most related questions to the subject here on this forum go unanswered or are answered vaguely.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |